Peugeot 308 Key Fob Replacement
Peugeot's 308 might be getting on a little but it's still attractive. It's not the most luxurious car in its class, but it's a relaxing and civilised drive.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. Whether the problem is ongoing or continuous the following tips will help.
Water Damage
If you accidentally drop your key fob in the puddle, or it gets wet while kayaking, canoeing, rafting or canyoning, the fob is likely to be damaged by water. The best way to prevent this from happening is to keep it in a dry bag whenever you're going outdoors or doing activities that require the fob to be exposed to excessive amounts of water.
You'll also need to ensure that the fob is dry prior to opening it and reusing it. If you notice any odors emanating from the fob like an industrial-like liquid smell or windshield washer fluid, it's another indication that it's been submerged in water.
A circuit board that is wet could cause the battery to discharge its charge or even explode. If you are able to get your 308 keyfob out of the water you need to turn the button side up and shake as much water out as you can before opening the casing. Take the battery out, and then clean the circuit board with a cotton swab that has been dipped into 90-percent alcohol.
Other reasons your Peugeot 308 remote entry keyless system might not work could be due to a dead coin-cell battery or receiver module issues signal interference or a defective chip. If none of these is the issue, try resetting the system by disconnecting the battery with 12 volts for approximately 15 minutes.
Dead Coin Battery
Peugeot cars are equipped with a remote-start feature that allows the driver to start the car from afar and then warm up or cool down the car prior to entering. This feature is extremely useful, especially during winter's cold and chilly months. However, it is possible that the remote start system ceases operating due to a range of reasons, like the battery in the coin is dead.
The coin-shaped battery located inside the key fob will last between two and four years based on how frequently it is used, the location it was purchased, and how it is used. The date of use will be written on the packaging or in the user's manual.
If the key fob stops working after exposure to water that is clean it is recommended to remove the battery, clean the chip using a paper towel and isopropyl alcohol, then dry it completely before replacing it. If the key fob has been exposed to salty or soapy water, it may have caused the chip to be damaged. You'll need to replace it.
If you're unsure whether the battery is defective it is possible to check its voltage using a multimeter connected to both the plus and minus terminals. If the voltage is lower than 12-13 volts, you should replace the battery. You can also reset your onboard computer by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first, then negative cable). The engine should then start after this.
Faulty Receiver Module
If you don't see the "Key Detected", it could be the receiver module malfunctioning. It's the component that sends an indication to the car when the key fob is activated, which also acts as an immobiliser. It also stops it from starting until the correct key is present.
This can be due to a number of causes, such as water damage or simply aging. If your Peugeot 308 key fob was exposed to dirty tap water, for instance the electronic chip inside may be damaged. In this scenario, you'll need to take off the battery and clean it thoroughly with isopropyl alcohol or an electronic cleaner. When the battery is dry, you can try again.
If the problem persists it is recommended to see an area Peugeot expert or locksmith. They'll be able use a diagnostic tool to assist in identifying the problem and fix it.
Losing your Peugeot keys to your car is an incredibly stressful experience. A reputable auto locksmith will be able to resolve the issue within minutes. They can cut a new key and programme it to your vehicle, ensuring you're on the road again as fast as you can. Click here to find a locksmith near you.
peugeot key fob replacement that is in the Peugeot 308 key fob plays an essential role in the remote control system. If it is damaged your car might not start or you may receive a message saying "anti-theft active". If this occurs, the only way to fix the problem is to get a new key. Auto locksmiths with experience can provide this service in the shortest time.
The chip inside the key fob of your Peugeot 308 could fail due to various reasons, including sweat, water damage, or dirt. If your Peugeot 308 key fob is exposed to soapy water, you should cleanse it immediately. You can use a paper towel and isopropyl alcohol for cleaning the electronic component. The battery should be allowed to fully dry.
Radio interference can cause the key fob to stop working. This can happen when other devices use the same frequency as your Peugeot keyfob. It could be caused by problems with the environment or objects close to the vehicle. It is recommended that you visit a Peugeot dealer if you have this issue.
The Peugeot Key Fob 207/308 is fragile and requires special care. It is important not to throw or drop the key fob. If you lose it, try to find it as quickly as possible. You can reset all the on-board computers by disconnecting the battery that is 12 volts for a few minutes. Be sure to disconnect the negative first, and then the positive.